Much like the engine of a new automobile, a new subwoofer must go through a short but important process of “break-in” before it is run under harsh conditions. The “break-in” process will ensure the subwoofer is able to perform as it has been designed to.
This process involves subjecting the subwoofer to no more than low-to-medium volume levels for a number of hours in the enclosure. 3-4 hours is generally sufficient for the subwoofer’s suspension to loosen enough to prevent the voice coil(s) from overheating and causing failure.
The break-in period is also effective in extending subwoofer life. Over-driving the woofer before it has been properly broken-in will usually result in premature failure and poor performance.
10 inch 600 watt subwoofer Powered by a Class A/B Amplifier
Passive Radiator
Variable Low-Pass Filter
High Level Input, Low Level Input
Phase Control
Variable Bass Boost
Dimensions: 11.22” x 11.22” x 11.22”, Weight: 18.61 lbs.
BOSS Audio Systems CUBE10 Car Subwoofer and Amp Package – Built-in Amplifier, 10 Subwoofer With Passive Radiator, Remote Subwoofer Control
Built-in Amplifier - A built-in 600 Max watt amplifier powers the 10” subwoofer
Passive Radiator – A driver unit that has its motor structure (magnet) removed, becomes a passive diaphragm. As a result, there is no Chuffing that you would generally get with a ported box, thus enriching the BASS & making the system more linear
Variable Low-Pass Filter - A low-pass filter is an electronic circuit that removes all the notes below the filter's frequency setting. You will use the Low-pass filter to primarily keep high notes out of your subwoofer(s)
High Level Input - Speaker level inputs are commonly referred to as high-level inputs. It will be used to connect the CUBE10 to your factory radio or an aftermarket radio that does not have low-level (RCA) inputs
Phase Control - Phase control lets you adjust the speaker phase with the amplifier if your speakers or subwoofer are hooked up “out of phase”
Low Level Input - Line level inputs, also known as RCA inputs or low-level inputs, use RCA interconnect cables to link the CUBE10 with the source unit. Most aftermarket radios have multiple pairs of RCA outputs that can connect to multiple amplifiers
Variable Bass Boost - Variable Bass Boost allows you to adjust the low bass within the boost range to just the way you like it , Specs - Dimensions: 11.22” x 11.22” x 11.22”, Weight: 18.61 lbs., Warranty - BOSS Audio Systems provides a Powerful 3 Year Platinum Online Dealer Warranty so long as the purchase is made through Amazon.com. We strongly encourage professional installation of this product to ensure proper and safe functionality